The Process of Troubleshooting Mechanical Seals – Part 1

The Process of Troubleshooting Mechanical Seals | Part 1

Chesterton

The 9 articles in this series will outline common issues with mechanical seals, how to notice them, and troubleshooting tips. Below describes what each part of the series attempts to address:

Part 1: 3 parts in the process of troubleshooting mechanical seals 

Part 2: Wide Wear Track 

Part 3: Centered/Miscentered

Part 4: Even/Uneven Wear Track 

Part 5: Scoring

Part 6: Chipping

Part 7: Coking

Part 8: Heat Cracking or Checking

Part 9: Blistering

There are three main parts involved in the process of troubleshooting mechanical seal failures:

  • Gathering all of the ACCURATE APPLICATION DATA available
  • Gathering all of the SYSTEM INFORMATION available
  • Making notations of the PHYSICAL EVIDENCE as you are inspecting each individual seal component during disassembly

The key to quick, accurate, and effective seal failure analysis is to be able to inspect the physical evidence (seal and rotating equipment) and relate the physical evidence to the application and/or system data. It is very important that all three parts of the information be available in order to make the proper recommendation to solve the problem.

There is no better place to perform a failure analysis than at the site the failure took place. The physical evidence and the application and system operation data is fresh in everybody’s mind. Troubleshooting mechanical seal failures is not a simple process, but with experience, product knowledge, and confidence you can be providing solutions to your customer and improving product reliability, thereby reducing plant downtime.

Be aware that there are often factors other than the mechanical seal that contribute to premature seal failure. Some of the other factors that should be considered are:

  • FLUID CHARACTERISTICS
  • EQUIPMENT CONDITIONS
  • SYSTEM OPERATION
  • SYSTEM/EQUIPMENT DESIGN
  • ENVIRONMENTAL CONTROLS
  • MAINTENANCE PRACTICES 4

Listed below are common factors that contribute to early mechanical seal failure along with some helpful questions that will improve your troubleshooting skills.

FLUID CHARACTERISTICS
  • Does it crystallize?
  • Does it coke?
  • Does it harden or setup?
  • What is the % concentration?
  • Is it a lubricating or non-lubricating fluid?
EQUIPMENT CONDITIONS
  • Measure the radial and axial movement.
  • What is the condition of the bearings?
  • Are there alignment problems?
  • Is the impeller balanced and positioned properly?
SYSTEM OPERATION
  • Does the system run dry?
  • Is thermal shock an issue for the mechanical seal?
  • What are the system cleaning procedures?
  • Is it a cycling process?
  • Is there water hammer?
  • Is cavitation a problem?
  • Where is the pump operating on the curve?
SYSTEM/EQUIPMENT DESIGN
  • What is the shaft L/D ratio?
  • What is the valve/piping arrangement?
  • Have there been any piping changes?
  • Are filters or strainers being used?
ENVIRONMENTAL CONTROLS
  • What is the flush pressure?
  • Is it reliable?
  • Do you need a dual mechanical seal?
  • Do you need to consider a steam quench?
  • Is there a cooling jacket?
MAINTENANCE PRACTICES
  • What are the mechanical seal installation practices?
  • Do the maintenance personnel require product training?
  • Is the pump repaired when the seal is installed?

Chesterton

This is a 9 part series. Click to view each article: 1 : 2 : 3 : 4 : 5 : 6 : 7 : 8 : 9 

idconadmin

idconadmin

EXPLORE BY TOPIC

Join the discussion

Click here to join the Maintenance and Reliability Information Exchange, where readers and authors share articles, opinions, and more.

Get Weekly Maintenance Tips

delivered straight to your inbox